I have given up on 1.1, it just doesn't want to work with my machine, I will stick with 0.9. I think I will have to try the other 8 revisions as a trial and error to see if one will work.Ī lot of hours searching and I finally have 0.9 running ok. I have found 9 different Hex file versions of the 0.9 for the atmega 328 so I tried the latest and it did flash but all the controls are opposite, left is right, forwards is backwards etc but I cannot swap wires round as on most boards because this one has plugs connected both ends of the wires.
The up/down, left/right and spindle control buttons were greyed out and I had the word "unknown" in the box where it usually says "idle or running. I managed to load 1.1 using the Arduino but still got the same result as I did using the Hex file.
0 kommentar(er)
